![]() And make sure you only use the stain-free variety if you’re using it in areas that have porous materials like marble or granite. Just remember to use it only on metal, never plastic. It’s cheap to buy, easy to apply, creates a watertight seal on metal parts, and easy to remove. How to Use Plumber’s Tape (Teflon Tape) Final ThoughtsĪs you can see, plumber’s putty is a great sealant to have in your DIY toolkit. Regular putty is oil-based and best used with metal parts, such as your faucet drain. Stain-free plumber’s putty is oil-free and therefore will not create stains on granite, marble, quartz, sandstone, Corian®, or any natural surface that is porous. What is the difference between stain-free and regular plumber’s putty? If you seal the tub, it will remain pliable for about two years if correctly sealed. You’re done! All you must do now is clean up and place any of the excess putty back into its container for the next job. The process is similar to smoothing down a bead of silicone from a caulk gun. Remove the excess with your fingers and make it look nice and smooth. Replace the PartĪs the part gets screwed in and tightened, you’ll see putty get squeezed out of the fixture. It also prevents the putty from falling off when you turn the part over. This will remove excess air bubbles from where it attaches to the surface and creates a more watertight seal. Gently but firmly press against the plumber’s putty. Start the putty rope at one end of the pipe and loop it around until it meets up with where you started. Loop the putty rope around the area of the pipe that you want to seal. Don’t be shy about using more plumber’s putty than you think you’ll need. You’ll want to roll it to the length and diameter you need to sufficiently cover the area you want to seal. Take a scoop of putty and roll it between your palms until it changes its shape into a rope (or snake). So, get those mitts near some heat before you move on to the next step. However, plumber’s putty is more effective when it is warmed up. This might sound like an odd second step. New metal surfaces (like a completely new faucet drain system) probably won’t require this cleaning, but it never hurts to check for and remove any dirt and debris. That means removing any previously used putty, tape, or adhesives. Make sure the metal surface is fully cleaned. Below you will find written directions on how to handle a job with plumber’s putty.įollow these steps to create a watertight seal: 1. Watch the video above on how to use plumber’s putty or watch it here on our YouTube channel. But it also comes in caulking tubes or, for small projects, in stick-like shapes. It is commonly sold in small, inexpensive plastic tubs. Therefore, it can be used to set bowls, fixtures, faucets, sink frames, and strainers. ![]() Why? In certain applications, like a common faucet drain, you want to be able to remove the drain easily for future repairs or replacements.įor example, it doesn’t crack separate, crumble, harden or shrink. ![]() It is also used to seal cracks that would otherwise cause leaks.īecause it’s not an adhesive (like silicone), it won’t stick to the parts you use it on. Plumber’s putty is a type of soft-set, pliable rubber for watertight seals in faucets and drains.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |